Copyright © 2008-2014 Far South Networks (Pty) Ltd
Solid green
K
Hardware Installation
Important:
Refer to the ComX Installation Guide for important safety instructions installation
guidelines wiring and surge protection mechanisms and recommendations
Available for download at$
http$%%wwwfarsouthnetcom%wp&content%uploads% (%8%comX &installation&
guidepdf
Ensure adequate ComX chassis ground 3zero impedance to earth bar4 and surge protection
mechanisms are suitably installed
The ComX server is powered using the VDC power adapter included with your unit Connect the
power adapter to the server and to mains supply and turn the server on
(
Connect any Comma iTA units to any available second and third LAN ports 3Eth Eth4 using Cat=e
cables
*
Connect the ComX server to a LAN switch using the first Ethernet port 3Eth4 using and a Cat=e
cable
=
Connect FXS ports to telephones fax machines etc using standard Cat( twisted pair cables
'
Connect FXO ports to telco lines PBXs etc using standard Cat( twisted pair cables
D
Connect BRI ports to telco NT equipment or PBXs using standard S%T RJ&*= cables
8
Connect PRI port to telco NT equipment or PBXs using standard E balanced RJ&*= cable
Accessing the Com.X10 server
1.
Default access details for the ComX are$
user: comma
password: farsouth
The ComX server GUI can be accessed using the url http$%%EipF where EipF is the IP addressed
assigned to the unit via DHCP or one of the statically configured IPs All administrative tasks
elaborated on below can be performed from the ComX GUI Please refer to the ComX Administrator#s
guide for more detail
3.
The ComX server can also be accessed via its serial port using a null&modem cable with the
following settings$
baud rate: 115200
