Wanderbox installation guidePage 11
3 Hardware Installation
Before you begin the actual installation, review the safety instructions and pre-installation
guidelines that follow.
3.1 Important Safety Instructions
When using your Wanderbox, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and injury to persons, including the following:
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a damp cloth for cleaning.
Do not use this product near water (for example, in a wet basement).
Do not place this product on an unstable cart, stand, or table. The product can fall,
causing serious damage to the product.
Slots and openings in the cabinet and the back or bottom are provided for
ventilation, to protect it from overheating; these openings must not be blocked or
covered.
This product should never be placed near or over a radiator or heat register.
This product should not be placed in a built-in installation unless proper ventilation
is provided.
This product should be operated only from the type of power source indicated in
the manual. If you are not sure of the type of power source to your building, consult
your dealer or local Power Company.
The mains power socket outlet must be located near the product and must be
easily accessible to allow plugging/unplugging.
Do not allow anything to rest on the power cord. Do not locate this product where
persons walking on it will abuse the cord.
Never push objects of any kind into this product through cabinet slots as they can
touch dangerous voltage points or short out parts that could result in a risk of fire or
electric shock.
Never spill liquid of any kind on the product.
To reduce the risk of electric shock, do not disassemble this product, but take it to
a qualified serviceman when some service or repair work is required.
Opening or removing covers can expose you to dangerous voltages or other risks.
Incorrect re-assembly can cause electric shock when the product is subsequently
used.
Unplug this product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
o
When the power supply cord or plug is damaged or frayed.
o
If liquid has been spilled into the product.
o
If the product has been exposed to rain or water.
o
If the product does not operate normally by following the operating
instructions.
©2018 Far South Networks
