Far Tools DWS 710E, Original Manual

Warning !

 You must observe the following basic safety in order to avoid electric shock, 

injury and fire hazard when using power tools. Read and follow these instructions before 

you start using a tool. These instructions must be kept secure.

•  The product should never be used near a hazardous area. 
• Do not let the wire in contact with a body part. 
• Use only extension cords intended for use in the workspace. 
•  Do not force the unit to perform inadequate work, such as coarse sanding, brushing, 

etc. Otherwise, this may cause danger and damage. 

•  Use only identical replacement parts when servicing. 
   Otherwise, safe operation can not be guaranteed. 
•  Whether the authorized accessories speed must be at least the same as the maximum 

speed of the device, otherwise they may break or crack if the operating speed exceeds 

the speed limit of the camera. 

•  Do not use damaged accessories. Before use, always check that the accessories are 

chipped or cracked. For example, to the sanding pad, please verify that the support 

plate is not cracked. Make sure everyone is out of the range of rotation of the device 

and operate The set at maximum speed for one minute, in order to fully test the 

accessories. 

•  Do not place appliance until it has completely stopped. Otherwise, you will lose control 

of the unit. 

•  Clean the orifice discharge device. 
•  During use, check the unit firmly with both hands in order to ensure safe operation. 
•  During sanding, do not use too abrasive. When choosing a sanding disk, observe the 

manufacturer’s specifications. Sandpaper beyond the sanding block is a risk of cuts and 

injuries and entrapment. 

•  The set may be connected to one extension tube to the maximum. 
•  You should always wear gloves and industrial safety goggles when using the sander 

drywall. 

•  Wearing tight-fitting clothing is mandatory. 
•  Always consider the reactions of torque. 
•  Wear a face shield to protect against hazardous dust and choose a suitable vacuum 

cleaner.

Using drywall sander :

Before adjusting, repairing or servicing the machine, you should always put the switch in 

the off position and disconnect the power cord magnetization sector !

Before first use :

•  Check the nominal frequency of the power supply matches the information on the 

nameplate. 

•  Before using the tool, read the manual carefully.

EN : 

Precautions when using a drywall sander

115159-5-Manual-K.indd   13

115159-5-Manual-K.indd   13

20/07/2021   17:01

20/07/2021   17:01