FAR DP2620IL, Manual

ENGLISH

ENGLISH

GB-11

GB-10

INSTALLATION

Position the appliance and allow it to stand for 

two to three hours before it is turned on for 

the first time to allow the system to settle. Do 

not position next to any heat source e.g. cooker, 

boiler or in direct sunlight etc.
Allow at least 10cm of space at the top and 10 

cm of space on both sides of the appliance and 

between the back of the appliance and the wall 

for adequate air circulation. The appliance is not 

designed for recessed installation (“building in”).
Install on a good firm level surface, and any 

unevenness of the floor should be corrected 

prior to installation, slight unevenness can be 

overcome by adjusting the front feet.
NOTE: If the appliance is positioned on a 

carpet, soft floor covering you should readjust 

the front feet once the appliance has had time to 

settle.

USE

•  This appliance is designed to operate in 

ambient temperature between 16°C and 38°C. 

If these temperatures are exceeded, i.e. colder 

or warmer, the appliance will not operate 

correctly. If the ambient temperatures are 

exceeded for long periods, the temperature in 

the freezer section will rise above -18°C and 

food spoilage may occur. 

•  Remove all packaging materials from the 

appliance. Wash the inside of the cabinet 

with lukewarm water and bicarbonate of soda 

(5ml to 0.5 liter of water). Dry the appliance 

thoroughly. 

•  When you use the freezer for the first time 

or after defrosting, set the thermostat control 

to the maximum position for at least 2 hours 

before introducing food to be stored, and then 

readjust to the normal position.  

•  If there is a power failure, do not open the 

door. Frozen food should not be affected 

if the failure lasts for less than 18 hours. If 

the failure is longer, then the food should 

be checked and either eaten immediately or 

cooked and then re-frozen.