Revisione - 03
Date 01-2011
17
GB
KJ 45/S
KJ 45/S
ATTENTION!
Disconnect the machine before carrying out the
above-mentioned operations.
CHANGE OF SIZE
(fig.
f8-f9-f10-f11
)
The riveting tool is supplied with
6 pairs
of threaded tie-rods
(
A
), heads (
B
), entreiners (
R
) and, spacers (
S
) only for tie-
rods from
M4
to
M6
(
f8
).
To change the size make as follows:
• Unscrew the cone-carrying head (
O
) by a
22 mm
standard
spanner (
f9
).
• Extract the threaded tie-rod, pushing and lifting it at the
same time (
f10
).
• After preparing the threaded tie-rod (
A
) of the size you
need, arrange and keep the components as shown in
f11
and assemble. Be sure that the components are correctly
placed, rotating the tie-rod by hand (
f11
).
ATTENTION!
• The side of the component (
R
) to be entered in the head
of the tie-rod is provided of a magnet to avoid accidental
fall during the operations of change of size.
• Screw the cone carrying heads (
O
) by a
22 mm
standard
spanner and clamp correctly.
M8 - M12
M4 ÷ M6
A
R
B
A
R
B
S
f8
22 mm
O
f11
f10
f9
