9
GB
KJ 70-A
Revisione - 00
Date 04-2017
INSTRUCTIONS FOR USE
I
INDEX
GUARANTEE AND TECHNICAL ASSISTANCE .............................. 9
SAFETY MEASURES AND REQUIREMENTS ............................... 9
TOOL IDENTIFICATION ............................................................. 10
GENERAL NOTES AND USE ...................................................... 10
MAIN COMPONENTS ................................................................ 10
TECHNICAL DATA ..................................................................... 10
PLACING OF THE INSERT ......................................................... 11
CHANGE OF SIZE ..................................................................... 12
TOOPING UP THE OIL-DYNAMIC CIRCUIT ............................... 13
DISPOSAL OF THE RIVETING TOOL ......................................... 13
CAUTION!!!
All the operations must be done in conformity with the
safety requirements, in order to avoid any consequence
for your and other people security and to allow the best
tool work way.
• Read the instructions carefully before using the tool.
• For all maintenance and/or repairs please contact
FAR
s.r.l.
authorized service centers and use
only original
spare parts
.
FAR s.r.l.
may not be held liable for
damages from defective parts caused by failure to
observe what mentioned above (
EEC directive
85/374
).
The list of the service centres is available on our website
http://www.far.bo.it ( Organization )
• The tool must be used only by expert workers.
• A protective visor and gloves must be put on when using
the tool.
• For topping up the oil, we suggest using only fluids in
accordance with the features specified in this working book.
• If any drop of oil touches your skin, you must wash with
water and alkaline soap.
• The tool can be carried and we suggest putting it into its box
after using.
GUARANTEE AND TECHNICAL ASSISTANCE
FAR
riveting tools are covered by a
12-month
warranty. The
tool warranty period starts on the date of delivery to the
buyer, as specified in the relevant document. The warranty
covers the user/buyer provided that the tool is purchased
through an authorized dealer and only if it is used for the
purposes for which it was conceived. The warranty shall
not be valid if the tool is not used or maintained as specified
in the instruction and maintenance handbook. In the event
of defects or failures,
FAR S.r.l.
shall undertake solely to
repair and/or replace the components it judges to be faulty.
SAFETY MEASURES AND REQUIREMENTS
• The tool needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the
tool is not fed.
• A safety balancer is suggested when it is possible.
• If the A-weighted emission sound pressure level is more than
70 dB (A), you must use some hearing protections (anti-noise
headset, etc.).
• The workbench and the work surface must be always clean
and tidy. The untidy can cause damages to people.
• Do not allow unauthorized persons to use the working tools.
• Make you sure that the compressed air feeding hoses have
the correct size to be used.
• Do not carry the connected tool by pulling the hose. The hole
must be far from any heating sources or from cutting parts.
• Keep the tools in good conditions; do not remove either safety
parts or silencers.
• After repairing and/or adjusting, make sure you have already
removed the adjusting spanners.
• Before disconnecting the compressed air hose from the tool
make sure that there is no pressure in the hose.
• These instructions must be carefully followed.
