GB
17
RAC 171
750348 - RAC171 – rev 12 - ( 04-2019 )
27 mm
H
RAC 171
EAC
M
18 mm
14 mm
M
N
A
MAINTENACE AND CHANGE OF SIZE
(fig.
f4-f5-f6-f7
)
The extended utilization of the riveting tool can cause the slipping
of the clamps on the nail due to the deposited impurities. For
this reason, it is necessary to lubricate the clamps after having
cleaned them with benzine or derivates. However, if clamps are
worn out and as a consequence their working is jeopardized,
replace them.
First remove the head which carries the nozzle (
H
), by means
of a standard spanner of 27 mm. Then, by using two standard
spanners of 18 mm and 14 mm, remove the chuck (
M
) and
extract the clamps (
N
).
The riveting tool is supplied, besides the nozzle series for FAR
rivets, with a series of accessories for using the rivets type
FARBOLT
, respectively of Ø 4,8 and Ø 6,4. For operating with
these rivets you have to replace the nozzles, the clamps and
the cone holding clamps.
When replacing the nozzle (
A
), use the proper supplied wrench
and screw the removed nozzle in it in order to avoid losing
the nozzle.
WARNING!
Desconnect air feed when performing those
operations.
f4
f5
f6
f7
DISPOSAL OF RIVETING TOOL
Follow the prescriptions of the national laws for
disposing of the riveting tool.
After disconnecting the tool from the pneumatic
system, disassemble and split all the components
according to the material: steel, aluminium, plastic
material, etc.
Then proceed to scrap the materials in accordance
with current laws.
