HOW TO USE YOUR RIVETING TOOL (fig. f1-f2)
After the clamping, the sheared nail is piped by the riveting
tool and ejected from the back into the special container (
A
).
By swinging the valve (
B
) you can adjust the suction power.
By the suction nail system, the rivet remains in the nozzle
also turning over the head of the riveting tool downwards: this
detail increases a lot the usefulness of the riveting tool.
Do not keep the rivet with your fingers!
DO NOT DISPERSE ANY NAIL!
MAINTENACE AND CHANGE OF SIZE (fig. f3-f4-f5-f6)
If you want to convey the sheared nails into a container, re-
move the nail deviator (
A
) and its reducer (
B
) from the riveting
tool. Connect a pipe Ø 10 x 8 © to the riveting tool introducing
it into the union (
D
)/
ATTENTION:
the bending radius of the pipe should not be
smaller than 300 mm and it should not be higher than 200 mm
compared to the riveting tool, as shown in the picture
f2
.
Do not remove the container (
C
) during the riv-
eting operation, as the nail ejection can cause
damages to the worker or to persons who are
nearby the work surface.
