Section II Operation Instructions
II-6
P/N 446613 Issue I Rev. A
13400 Operating Instructions
Alarm Operation
In case of alarm, the appropriate Zone Alarm LED flashes and the System Alarm LED flashes, and the
panel buzzer sounds. Local audible and visual signals and remote alarm signals operate.
When an alarm occurs, proceed according to the established emergency plan. Assure that all personnel
are accounted for, and notify the Fire Department to advise of the alarm and/or verify that an automatic
signal has been received at the Fire Department
.
Authorized Personnel Only
To silence the alarm:
To silence the notification appliances after evacuation, where permitted, open the front panel door
and press the Alarm Silence switch. The notification appliances and panel buzzer will be
silenced, and LED indications will change from flashing to continuous.
Note: Do not reset the panel until the alarm has been cleared.
Warning: Alarm silence inhibit (if set) prevents the alarm from being silenced for a
predetermined time.
To reset panel after alarm:
When the alarm condition is corrected, return the panel to normal standby operation by opening
the front panel door and then pressing the System Reset switch
.
Trouble Operation
Trouble is indicated by:
System Trouble LED flashes
Specific trouble LEDs may light
Panel buzzer sounds
To silence the trouble buzzer:
Open the front panel door and press the Trouble Silence switch. The system Trouble LED and
individual trouble LED(s) may change to continuous display. When the trouble condition has been
cleared, you may need to reset the panel to restore to a normal standby condition.
Warning: Leaving the panel in a trouble condition may cause a fire alarm condition not to
initiate a fire alarm sequence.
Normal Standby Condition
The green AC Power On LED will be lit and no other indicators on
.
For service, contact: __________________________________________ (Company)
Telephone Number: ___________________________________________
Frame these instructions and mount them near the control unit for operator reference.
446691 Issue I
firealarmresources.com
