RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8-40
Replacing the Top Cover Assembly (includes Print Circuit Board) (continued)
Steps Procedure
3
Remove the Input Door and Right End Cap. See
Replacing the Input Door
Assembly (D900148)
. See
Replacing the Right End Cap (D900065-01 and –02)
.
4
Remove the Card Output Door and Left End Cap. See
Replacing the Output
Door Assembly (D900092)
. See
Replacing the Left End Cap (D900064)
.
5
Remove the Card Output Door. See
Replacing the Output Door Assembly
(D900092)
.
6
Use a Torx T-10 screwdriver to remove two (2) F000178 screws that secure the
Top Cover Assembly (see previous page) to the Main Printer Chassis. (
Note:
The Top Cover and the Board do not separate.)
7
Disconnect all the connections to the Main Board.
8
Pull the Top Cover Assembly back to release it from the front mounting clips.
9
Replace the Top Cover Assembly. This procedure applies to these components:
•
DTC300 Top Cover Replacement (044304)
•
DTC300 Flip Cover Replacement (044305)
•
DTC300M Top Cover Replacement (044306)
•
DTC300M Flip Cover Replacement (044307)
•
DTC400 Top Cover Replacement (044308)
Continued on the next page