RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8-55
Replacing the Ribbon Motor Supply Assembly (D900121), O-Ring Drive Belt
(140212), Encoder (A000126) Sensor and Motor (D840980) (continued)
Steps Procedure
9
Use a Torx T-10 Screwdriver to remove the two (2) screws (F000170) that
secure the Motor (D840980) to the Ribbon Supply Assembly, as shown below.
10 Remove
the
Motor.
11
Use a Torx T-10 Screwdriver to remove the two (2) screws (F000177) that
secure the Encoder Sensor (A000126) to the Ribbon Supply Assembly, as
shown below.
12
Remove the Encoder Sensor.
13
Reverse to reassemble.
Continued on the next page
