RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
5-22
Resolving a Ribbon Break Jam Error (continued)
Step Procedure
2
Open the front cover and remove the Ribbon Cartridge.
•
If Ribbon is broken, continue to Step 3.
•
If Ribbon is in good condition, continue to Step 6.
3
Adjust the print offset. See the
Using the Print Top of Form Option
procedure.
If the issue persists, continue to Step 4.
4
Repair the Ribbon and wind up the take-up roll 4 color panels past the
damaged area.
a. Press on the
Resume
button.
b. If the issue persists, continue to Step 5.
5
Use the Fargo Diagnostic utility to cycle the Printhead to ensure proper
printhead operation. See the
Using the Diagnostic Utility tabs
procedure.
•
If the Printhead does not cycle properly, see Resolving the Headlift Motor /
Sensor Error.
•
If the Printhead functions properly, continue to Step 6.
6
Replace the Ribbon Cartridge.
a. Press on the
Resume
button.
b. If the issue persists, continue to Step 7.
7
Remove the rear cover in order to check that the Ribbon Encoder Sensor is
securely connected to the J-4 Main Board connection and to the Encoder
Sensor.
a. Press on the
Resume
button.
b. If the issue persists, replace the Encoder Sensor.
