C50 Card Printer Service Manual PLT-01278 rev 1.1
August 2013
Page 42
HID GLOBAL CONFIDENTIAL AND/OR PROPRIETARY INFORMATION. This document contains confidential and/or proprietary information,
which may not be duplicated, published, disseminated or disclosed, or used for any purpose, without the written consent of HID Global
Corporation. If you are an unintended recipient of this information or are unwilling to accept the above restrictions, please immediately return
this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..
3.11
Remove/Replace the PCB board (A000365-01)
Step Procedure
1
Remove Supply Spindle-RFID assembly. See procedure above (D930015-01).
Un-snap the PCB from the frame.
The PCB with the HOLES is set under the corner tabs.
Lift up this end first. See picture below.
2
Replace with new PCB and/ or Cable.
3
Insert one end first then snap into the corner tabs. Replace cable to J9.
9
For both procedures route the cables under the holding tab.
10
Reverse assembly to reinstall parts
11
Procedure is complete.