FOR RESTRICTED USE only
Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
5-17
Performing the procedure for the DTC550 Card Lamination Module
Attachment Kit (continued)
Step
Procedure
12
Once all print supplies are installed, apply power to the Lamination Module
and run a test print to make sure installation was successful.
You must have PolyGuard™ overlaminate and a full-color Print Ribbon
installed to print this test image.
To test, go to the Printer’s LCD display and select
MENU
,
PRINT TEST
IMAGE
and make sure that Lamination is set to ON. Then select any image
from the test images.
The test image will begin printing after a few seconds and will both print and
laminate the card.
13
You have completed the procedure.