18
The FARHO radiator needs 230 V input.
It must be pointed out that the lead cable used to fit the FARHO XANA
PLUS model must be of appropriate diameter in accordance with the
length, type and power of the radiator in question (See Low Voltage
Regulations). According the regulations, it must be possible to insulate
the supply circuit by means of an omnipolar cut-off element, such as,
for example, a break switch. The disconnecting contact must be at least
3 mm.
A plug can be used to connect the radiator as long as direct access
can be had to the socket. Another possibility is to connect the radiator
directly to a fixed installation by means of a blank case fitted with an
internal terminal strip.
The heater should be connected to the mains only after it has been
hung from the brackets that have been previously secured to the wall
to hold it (Consult the section entitled “FITTING” in this manual).
The power lead must not lie against, or touch, any part of the heater.
Whenever necessary, and in order to ensure avoidance of contact a
cableway strip, clips or some other type of securing component will be
employed. Perform the operations listed above in reverse order to
disconnect the heater from the mains
.
FITTER’S INSTRUCTIONS
POWER SUPPLY
