Maestro Navigator 3.5.3.doc
140
3. Computer does not shut down properly
Every time I turn on the navigation computer I get an error message saying “computer
was not shut down properly.” To avoid seeing this message, always shut down the
computer by using the commands in the NavPanel or in the Navigator Chart Plotter
Navigation Menu.
To shut down the computer from within the Navigator chart plotter:
Press
Exit, Shut Down Computer
.
To shut down the computer from the NavPanel: Press the
Shut Off
button.
Notes!
Always shut down your computer using one of these methods - do NOT turn off the
computer by pressing the Power switch on the dashboard or turning off the navigation
computer’s circuit breaker on your vessel’s electrical panel. Doing so can result in
system errors.
If absolutely necessary, you may shut down the navigation computer by pressing the
Power button on the monitor and holding it for approximately five seconds until the
navigation computer shuts down. This method, however, should not be used
excessively.
4. Computer clock resets itself
The Navigation computer’s clock resets itself each time the computer is turned on.
This indicates that the computer’s battery needs replacement.
Contact Faria technical support to verify the problem and get instructions on removing
the hardware and shipping it for replacement.
Troubleshooting: GPS
5. Navigator is not receiving a GPS signal.
First, make sure that the GPS antenna wire is plugged into the back of the Maestro
Computer NMEA adaptor Cable, Port 4 (White).
Also, check the GPS antenna and cable on top of the cabin for damage.
If the antenna wire is plugged in, and you find no damage, contact Faria from your
vessel and a product support specialist will work with you to determine the problem.
Maestro Navigator is equipped with diagnostic software tools that may be used to verify
GPS data output. Faria’s technical staff can provide specific instructions for testing the
GPS data feed.
Note!
In order for the WxWorx Weather to be able to show the vessel, the Chart Plotter needs
to be running. The Chart Plotter gets the GPS data and makes it available to the
WxWorx application.
Troubleshooting: Radar
6. Error: Cannot detect radar unit
Summary of Contents for Maestro
