Assembly - 1370, 1385, 1395, 13114 Backsaver Auger
8
Figure 18
Rotate the pivot yoke (Item 1) up
[Figure 18]
.
Bottom Cylinder Pin Sizes:
• 1-1/2” x 12-3/8” - 1370 Models
• 2” x 14-13/16” - 1385 & 1395 Models
Align the pivot yoke and connecting link. Install
the bottom cylinder pin (Item 2) through the
connecting link and first side of the pivot yoke
[Figure 18]
.
Figure 19
NOTE:
It is recommended to leave the plastic on
the hydraulic cylinders during assembly.
This will help to prevent damage to the
paint and minimize touch-up painting.
Install a chain or strap (Item 1) through the base
end of the hydraulic cylinder. Connect the chain or
strap to an approved lifting device
[Figure 19]
.
Raise and move the hydraulic cylinder to the
assembly area.
Figure 20
Lower the hydraulic cylinder and align the rod end
of the cylinder with the pivot yoke (with grease
zerks facing as shown).
Continue installing the bottom cylinder pin (Item
1) through the connecting link and opposite side
of the pivot yoke
[Figure 20]
.
Narrow Rim Washer Sizes:
• 1-1/2” x 10 Ga. - 1370 Models
• 2” x 10 Ga. - 1385 & 1395 Models
Cotter Pin Sizes:
• 1/4” x 2” - 1370 Models
• 5/16” x 3” - 1385 & 1395 Models
Install one 2” narrow rim washer (Item 2) and one
cotter pin (Item 3) onto the bottom cylinder pin
[Figure 20]
.
NOTE:
Do not remove chain from base end of the
cylinder.
1
1
3
2
1
2
Summary of Contents for 1370
Page 1: ...062019 FK429 ASSEMBLY MANUAL BACKSAVER AUGER Models 1370 1385 1395 13114...
Page 2: ......
Page 92: ...Assembly 1370 1385 1395 13114 Backsaver Auger 90...
Page 93: ......