Assembly - 1370, 1385, 1395, 13114 Backsaver Auger
61
IMPORTANT
Do not remove the drum to install the cable.
Figure 179
Install the cable clamp (Item 1) using the two bolts
provided with winch. Leave bolts loose
[Figure
179]
.
Route the cable over the top of the hand winch
drum.
Install the cable (Item 2) from the inside of the
drum through one of the dimpled holes (Item 3) in
the outer plate
[Figure 179]
.
Loop the cable around the drum bearing. Feed
the cable between the loop and outer plate, then
through the cable clamp.
Leave approximately 1” of cable extending past
the clamp. Tighten and torque the clamp bolts to
approximately 2 ft.-lb. (3 N•m).
Turn handle to wrap cable around drum.
HOPPER SAFETY HOOK
Figure 180
Install the quick link (Item 1) through the eye of the
hook (Item 2). Install the quick link onto the safety
chain at the desired location. Tighten the quick link
nut to securely fasten the quick link and hook to
the safety chain
[Figure 180]
.
NOTE:
The quick link and hook may need to be
adjusted higher on the safety chain to
make sure the hopper is approximately
16” above the ground for transport.
1
1
3
2
2
Summary of Contents for 1370
Page 1: ...062019 FK429 ASSEMBLY MANUAL BACKSAVER AUGER Models 1370 1385 1395 13114...
Page 2: ......
Page 92: ...Assembly 1370 1385 1395 13114 Backsaver Auger 90...
Page 93: ......