Operation - 7420, 8420, 8420G
30
Connecting The Snowblower To
Tractor
Always inspect the tractor’s three-point hitch
and snowblower three-point mounts before
connecting. See the tractor’s owner’s manual.
Move the tractor drawbar into the storage position
or remove (if necessary) to prevent interference
with snowblower operation. (See the tractor’s
operator’s manual for the correct procedure.)
Figure 15
Remove the top implement mounting pin (Item 1)
[Figure 15] and linch pin.
Remove the linch pins from the left and right lower
mounts (Item 2) [Figure 15].
Enter the operator’s position (See “Entering The
Operator’s Position” in Operation section).
Move the tractor into position in front of the
snowblower.
Move the tractor backwards, aligning the tractor’s
three-point hitch and snowblower three-point
mounts.
Leave the operator’s position (See “Leaving The
Operator’s Position” in Operation section).
WARNING
AVOID INJURY OR DEATH
Before moving the tractor, look in all directions
and make sure no bystanders, especially small
children are in the work area.
Do not allow anyone between the tractor
and the equipment when backing up to the
equipment for connecting.
Install the left and right lower three-point mounts
of the tractor to the snowblower left and right
lower mounting pins.
Reinstall the linch pins.
Note: Always use implement mounting pins of
adequate size and strength and a retaining
pin with a locking device.
Lower the top link of the three-point hitch until it
aligns with the implement upper mount.
Reinstall the mounting pin and linch pin.
Note: It may be necessary to lengthen or shorten
the top link to align it with the implement
mounting hole. (See the tractor’s operator’s
manual for the correct procedure.)
The implement can be leveled front to back by
adjusting the top link. (See the tractor’s operator’s
manual for the correct procedure.)
Adjust the lower link sway chains or blocks on the
tractor to restrict side movement of the snowblower
when operating.
1
2
2
Summary of Contents for Allied 8420G
