Stop operating immediately if blades strike a foreign object. Repair all damage and make certain
rotor and blades are in good condition before resuming operation.
WARNING
Always disengage the tractor PTO when the driveshaft exceed an angle of 10 degrees up or down
while operating. An excessive angle with driveshaft rotating can break the driveshaft and cause
flying projectiles.
CAUTION
Avoid clutch's overheating caused by too long or frequent slipping of the clutch, since it can damage
the clutch components. Before checking slip clutch, make sure it has cooled. The clutch can be
extremely hot and cause severe burns.
CAUTION
Prolonged use of the tiller can cause overheating of the gearbox. Do not touch the gearbox during
use and immediately after, it could be extremely hot and cause severe burns.
WARNING
All adjustment operations on the tiller must be performed by qualified and trained operators, with
the tractor engine off, the PTO disengaged, the tiller lowered to the ground or on security stands,
the ignition key off and the parking brake set.
3.4.
TRANSPORTING SAFETY INSTRUCTIONS
WARNING
Before transporting, determine the stopping characteristics of the tractor and implement.
WARNING
Transport only at speeds where you can maintain control of the equipment.
WARNING
When driving on roads, the implement must be in transport position adequately raised from the road
surface, with tractor lifting hydraulics locked so that the tiller cannot be lowered accidentally.
DANGER
The implement may be wider than the tractor. Pay attention during transporting to persons, animals
or obstacles exposed.
WARNING
When turning, use extreme care and reduce tractor speed.
WARNING
Do not operate the tractor with weak or faulty brakes or worn tires.
CAUTION
Always use tractor lighting system and auxiliary lighting system for an adequate warning to operators
of other vehicles, especially when transporting at night or in conditions of reduced visibility.
DANGER
In case of tiller lifting, make sure that the lifting device chosen is suitable to perform the operation
safely, and use only the lifting points prescribed on tiller.
Summary of Contents for FTC Series
