EN
5) After treatment
•
At the end of the treatment, switch the appliance off using the ON/OFF switch. The blue
power indicator light will switch off.
•
The appliance is provided with a liquid level sensor that stops the device when the medi-
cinal product reservoir is empty. For technical reasons, a very small amount of product will
be left in the reservoir and must be disposed of before putting the device away. Make sure
that there are no batteries in the device during use.
•
When using the portable battery charger/power supply unit, remove the plug from the
mains socket after use.
28
•
After assembly and before use, pour sterile saline solution or deionised
water into the medicinal product vessel and press START/STOP to check it is
working correctly.
•
To use the mouthpiece correctly, the liquid should not be directed towards the
tongue.
•
Do not swallow the liquid, make sure it reaches the intended area.
•
Breathe regularly and without sudden movements to avoid potential obstructions.
If so, the red indicator light will flash continuously and will switch off automatically.
The nebuliser will not operate if the medicinal product vessel is empty. Tilt the main
unit slightly towards you to wet the vibrating mesh with the medicinal product.
•
Nebulisation will only occur if the vibration device is immersed in the medicinal
product.
•
When the medicinal product level is low, tilt the device towards you from the
START/ STOP side and collect the medicinal product that has accumulated on the
plate to use all the residual product.
•
The device must be protected against blows, as they could break the plate.
•
When the red low power indicator light continues flashing slowly, the power supply
is low. Insert new alkaline batteries or connect to the power supply unit as soon as
possible, as an alternative to batteries.
•
Do not shake the device violently during use, otherwise it will switch off automati-
cally.
•
The device may not be used with hard water, as it could damage the appliance.
