FARMI 351P
21
8h
8h
20h
A
B C
MAINTENANCE
SAFETY
Disengage the P.T.O and turn the
tractor off before you service the
winch, remove the keys so the
tractor cannot be started up acci-
dentally.
LUBRICATION
Do not oil the drive chain, becau-
se the oil will work its way to the
clutch!
The cable drum, main sprocket and snatchblock are
fitted with self lubricating bearings.
Following points require lubrication:
1. Grease the drum clutch parts after every 500
working hours. Always use good quality lubricati-
on grease.
2. Grease the PTO-shaft regularly and aways before
use as shown in figure 15.
3. Grease the drum chain lightly (not with oil) after eve-
ry 50 working hours with spray type, hardening
chain grease. Wipe off the excessive grease.
Fig. 15. P.T.O shaft lubrication
CLUTCH ADJUSTMENT
1. Loosen the nuts A and B at both ends of the drum
axle. Wrench opening 1 7/16” (36 mm).
2. Adjust the clutch by turning the axle C with 9/16”
or 14 mm wrench. The clutch tightens clockwise,
loosens counterclockwise. Turn max. 1/4 turn.
3. After adjustment retighten the nuts A and B on
the ends of the drum axle.
4. Pull the control rope. The lever should move up
1.5” (4 cm) before the clutch engages. If the clutch
engages earlier loosen the clutch setting.
Fig. 16. Clutch adjustment
h= working hours
When used in winter
the guard tubes must
be greased to avoid
freezing.
Swing joints sideways for greasing
Apply grease inside the
outer telescopic profile
DANGER!
!
CAUTION!
!
Summary of Contents for 351P
