FARMI 61
23
35 kg
C
Fig. 16. Clutch adjustment
CLUTCH ADJUSTMENT
The clutch is easy to operate. It does not exert to keep
the clutch pulled because the lever is pulled over the
highest transfer strength 35 kg outside up to the im-
pact. In impact proximity the transfer strength is only
10-15 kg.
It is important that the clutch is
adjusted correctly and the im-
pact is not changed, otherwise
exists danger that the clutch
goes beyond the so-called dead
point and cannot the drive any
longer be switched off.
CHECK
• Measure the strength of the control rope e.g. with
the help of a spring scale or a weight.
• If the maximum force is below the desired level,
tighten the clutch. If the force exceeds the desired
level, loosen the clutch.
ADJUSTING
1. Loosen the axle nut’s (C) lock screw.
2. Turn the nut (C) (horizontal width: 50 mm) slightly
in the required direction – clockwise to tighten
the clutch and counter-clockwise to loosen it.
3. Use the scales to pull the clutch lever (A) close to
the limiter (B).
4. After reaching the desired maximum force, lock
the nut (C).
If you overtighten the nut (C), the
string force will increase but the
winch will not pull well.
If the nut is too loose, the string
force will be light but the clutch
could slip.
WARNING!
!
CAUTION!
!
