5
CANOPIES
Revision date: 10.13.15
The following graphics and photos will help you identify the
different parts and show you how they are used.
(Some parts are not shown.)
CC4595
Tie Down 8'' Snugger Ball
102193
3-Way Coupler
3-Way Coupler (includes lock bolt)
3-Way Coupler (no lock bolt)
102194
4-Way Coupler
There can be two types of couplers used during the assembly of the shelter: those that include an installed locking eyebolt
and those that do not. See above.
If the couplers included with your shelter do not have an installed lock bolt, u
se a self-tapping Tek screw
to secure the
different pipes to the couplers during the assembly process. The self-tapping Tek screws are included with the shipment.
ATTENTION:
Tek screws are sent with all shelters of this type. For couplers with locking eyebolts, install the Tek screws at
each pipe connection for additional security if desired.
WARNING:
To prevent personal injury and damage to the shelter,
fasten and tighten a Tek screw
at each pipe and
coupler joint.
To prevent cover damage, install the Tek screw so that it
does not
touch the main cover or any optional side or end
panels once these are installed.
ADDITIONAL PARTS IDENTIFICATION NOTES
In some instances, there can be differences between the parts that are shown and referenced in the instructions and
the parts that are shipped with the shelter. These differences
do not
affect the integrity of the shelter, but can change the
assembly procedures.
The information that follows identifies possible changes in the assembly procedure found in this instruction document.
Please implement these changes during the assembly of the shelter.
