POLY BUILDINGS
30
Revision date: 03.15.12
14. Adjust the roll-up cover conduit so that it reaches the
gearbox and secure the cover to the conduit using half
of the (#CC6212) fabric clips and Tek screws.
15. Roll the conduit toward the frame and up to the
gearbox to wrap the excess cover onto the conduit.
16. Attach the rolled conduit to the square shaft of the
assembly by inserting a 5/16" x 2-1/2" bolt through the
hole in the conduit and tubing adapter. Tighten the nut.
NOTE:
It may be necessary to trim the conduit to the
proper length or adjust the threaded rod or both so the
conduit aligns with the gearbox.
17. Attach the crank handle (#102480) to the Twist-of-
the-Wrist assembly. (Cover is not shown in the above
diagram.)
18. Test the operation of the Twist-of-the-Wrist assembly.
NOTE:
If the cover rolls in the desired direction, but you
want to turn the crank in the opposite direction for the
same result, unbolt the gearbox, and remount it upside
down
on the same side of the mounting bracket
.
Roll-Up Cover
Conduit
(Cover is not
shown.)
Fabric Clips
TWIST-OF-THE-WRIST ASSEMBLY INSTALLATION
(CONTINUED)
ANTI-BILLOW ROPE INSTALLATION
Gather the parts:
• Anti-billow rope (#CC5310A)
• Fender washers (#FAMF03B)
• Eyebolt 5/16" (#FA2071)
• Nut 5/16" (#FALB02B)
• Tek screws
Anti-billow ropes secure the roll-up sides when they are in
the down position. Complete the following steps to install
the ropes.
1. Using the Twist-of-the-Wrist assembly, roll up the
sidewall so that it is a few inches above the ground.
2. Drill a 5/16" hole about 1-1/2" above the bottom of the
end rafter.
3. Move up the rafter leg to the main cover conduit and
install a Tek screw and fender washer through the
cover material and into the main cover conduit.
Rafter Leg
5/16" Eyebolt
FA2071
Customer-Supplied
Baseboard
Anti-billow
rope
FALB02B
Nut
NOTE:
Do not tighten the Tek screw completely, leave
room for the rope to fit behind the washer.
4. Move to the bottom of the second rafter and install
an eyebolt into the base of the rafter as described in
previous steps.
13. Slide the Twist-of-the-Wrist gear box assembly onto the
aluminum channel from the ground end. (This is the
free end of the channel.)
