Visit
www.ClearSpan.com
for additional products and customer assistance.
CLEARVIEW
™
PANELS
PREPARE THE FRAME AND HANG THE PANEL
Gather the Tools and Materials
Screw Hooks
Eye Screws
Drill bit
Variable speed drill
•
•
•
•
With the help of an assistant, hold the panel centered
on the outside of the opening high enough that the
bottom of the panel does not touch the ground or floor.
NOTE:
To prevent wear do not let the panel touch the
ground or floor.
Mark the frame where each grommet will be located.
Draw a straight line between the first and last marks on
the frame. This assures the panel hangs straight and
does not sag in the middle.
Drill pilot holes along the straight line and insert screw
hooks into the frame at each mark for a grommet.
Drive the screw hooks into the frame to the same depth
so the panel will hang evenly. Turn the open side of the
hooks upward.
1.
2.
3.
4.
5.
Hang the panel on the screw hooks by slipping the
grommets over the open end of the hooks.
6.
INSTALL THE ROLL-UP COMPONENTS
Gather the Tools and Materials
Pulleys
Rope Cleat
Nylon Cord
Drill bit
Variable speed drill
•
•
•
•
•
Slip a 7/8'' nylon pulley on the second screw hook from
each end of the panel. Attach additional pulleys to the
screw hooks along the panel no more than 72'' apart.
1.
Attach a rope cleat to the outside of the frame about
five (5) feet above the ground where it is convenient to
reach. The cord to roll up and unroll the panel will be
attached to this cleat.
3.
Drill pilot holes and insert eye screws
inside
the frame
opposite each screw hook with a pulley.
2.
