44
Revision date: 02.17.23
1
Assembly Instructions
ASSEMBLE BENCH TOP SUPPORTS
Use the photos and information that follows to construct the bench top frame supports.
The 12' bench has four (4) support assemblies. The 8' and
10' benches each have three (3) supports.
Gather the parts required to complete one (1) support assembly:
• (2) S125P03175 square tube for legs
• (1) S125P018 square tube crossbar
• (4) 112391 four-bolt clamps
• (8) FAG102B (1/4" x 3/4" hex bolts)
• (8) FALB10B (1/4" nuts)
• (12) FA4482B Tek screws
1. Gather the parts.
2. Construct two bracket assemblies. Do not
tighten the bolts at this time.
3. Slide the assembly onto one S125P03175
square tube leg pipe.
4. Set assembly flush with the end of the
square tube.
5. Slide the S125P018 crossbar square tube
into the bracket assembly.
IMPORTANT:
Set tubes flush with the
ends of the bracket assembly.
