2
Revision date: 03.08.17
Color Coding
READ THIS BEFORE YOU BEGIN
Purchased greenhouse and all accessories & systems require a specific installation sequence. All components have
been separated into different categories based on common grouping and/or the chronology of installation. Each
category has been color coded. All parts within any given color category will be labeled accordingly, and each color
category will have its own respective instruction manual.
The following illustrates a highly recommended order in which all components should be installed.
IMPORTANT:
There are some procedures that can occur simultaneously, depending on available assistants and
equipment, but there are some procedures that MUST be done in chronological order.
Before you begin,
review
below step recommendation and all technical documents to better understand overall building kit design.
Near the beginning of each color-coded instruction guide, you will find information to lead you through the installation
and assembly steps. This information identifies at what point during the assembly the respective components are
installed or attached to the main building frame.
Since we cannot anticipate changes made by the customer/contractor, all instructions assume the use of accessories
purchased from us to be used on the building the accessory was designed for. Each instruction guide presents the
basic steps to install the color-coded components.
When in doubt, consult the services of a qualified contractor experienced with the assembly of similar structures.
1
RED
- MAIN FRAME (Rafters, Purlins, Chord Support and Cabling)
ORANGE
- END WALL FRAMING (Columns, Cross Beams and Door Framing)
BLUE
- END WALL CLADDING (Polycarbonate, Termination and Flashing)
YELLOW
- EVAPORATIVE COOLING (Framing, Cooling Pads and Plumbing)
BROWN
- END WALL VENT (Framing, Motor and Drive Shaft)
WHITE
- VENTILATION (Exhaust Fans, Ceiling Fans and Light Traps)
PURPLE
- STATIC BLACKOUT (Monofilament, Fixation and Sealing)
BLACK
- MOVABLE BLACKOUT (Fabric, Leading Edge, Motor and Drive Shaft)
GRAY
- BLACKOUT SIDE POCKET (Framing and Polycarbonate)
2
3
6
7
8
9
10
11
4
GREEN
- ROOF CLADDING (Film, Inflation Kits and Termination)
PINK
- AIR DISTRIBUTION (Fan, Vent Tube and Shutter)
5
