25
Revision date: 03.08.17
MOTOR & DRIVE SHAFT COMPONENTS (continued)
End Wall Power Vent
1. Set one 115093 motor on a flat surface and
align 113652 coupling and motor sprockets
with chain.
4. Locate the two (2) inner link spacers.
2. Wrap chain around the two separate
sprockets.
5. Using a needle-nosed pliers, add the two (2)
inner link spacers to chain.
NOTE:
After adding one spacer, push connecting
link through the chain a little to hold spacer
in place. Then add the second spacer. Push
connecting link through second spacer until ends
of connecting link are visible. See arrow above.
3. Take connecting chain link and slide it
through first chain until ends are flush with
link of first chain section.
6. Flip the link ends down and over the
sprocket and push connecting link through
the outer chain links until connecting link is
tight to inside chain.
113652 Chain Coupling
115093
Motor
