5
Revision date: 12.02.16
Baseboards and Ribbon Boards
A customer-supplied baseboard
is recommended
for roll-
up sides that include the stabilizer bar. A baseboard runs
the length of the frame and provides a seal between the
ground level and the stabilizer bar.
All baseboard and ribbon board material and
fasteners to secure these to frame are supplied by
the customer. See photo below.
Dimemsions
Recommended baseboard dimensions are 2" x 8" and
ribbon board dimensions are 2" x 6" (minimum).
Recommendation: Use two (2) carriage bolts (exterior
finish) per rafter connection to secure the baseboards
and ribbon boards to the rafter legs/ground posts.
Actual frame shown in the examples above may differ.
These are presented for illustration purposes only.
Ground
Level
Inside of
Shelter
Outside of
Shelter
Secure baseboard (and ribbon
board) joints between rafters
as shown for best results.
RIBBON BOARD FOR ROLL-UP SIDES—OPTIONAL
In some instances, a ribbon board is installed along
the side of the frame. This is optional for buildings with
roll-up side panels.
Customer supplies the materials and
fasteners for the ribbon board.
Stabilizer Bar
Baseboard
DIAGRAMS ARE NOT TO SCALE.
5/16" Carriage
Bolt (supplied
by customer)
2" x 8" Baseboard
(customer supplied)
Ground
Level
2" x 6"
Ribbon Board if used.
(supplied by customer)
111613Z144
End View
5/16" Carriage
Bolt (supplied
by customer)
FAH005B Bolt
FALB01B Nut
FALF01B Fender
Washer
Rafter Leg
or Ground
Post
