37
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 06.06.18 113836_37_38_39R
ATTACH CONDUIT TO ROLL-UP SIDE PANEL
Gather parts:
• Assembled conduits
• Fabric clips #CC6212 (Divide quantity in half.)
• Tek screws (#FA4482B)
To this point, film covers are secured to the greenhouse.
Roll-up portion of cover film along both sides is secured to
and hanging down from u-channel.
1. Unfold remaining portion of cover film (if needed) and
evenly stretch it out on along the frame.
2. Set assembled conduit on edge of film panel.
ATTENTION:
Allow a few inches of the conduit to
extend past the end of the greenhouse end wall at the
end where you want to install gearbox assembly for the
roll-up side.
3. Working from
inside the frame
, roll assembled cover
conduit onto the edge of film panel.
4. Verify that film and conduit are evenly positioned and
tuck film edge under the conduit. Rotate conduit and
film clockwise.
5. Ensure that panel is even and secure film to the conduit
using FA4482B Tek screws and CC6212 fabric clips
evenly spaced along the conduit.
6. Continue rolling excess film around conduit.
7. Repeat these steps for the other side of shelter using
remaining half of fabric clips.
8. With film panel rolled onto each conduit, continue with
the
Twist-of-the-Wrist Assembly
procedure.
TWIST-OF-THE-WRIST ASSEMBLY
Gather parts:
• Aluminum channel (102570)
• Drive handle
• Gearbox and gearbox drive
• Mounting plate
• Bearing and threaded rod
• 3/8" nuts and washers
The Twist-of-the-Wrist Assembly is designed to roll up a
portion of the sides of the structure. The following steps
describe the assembly and its installation.
Inside View
Diagram may show a different model and is used for
illustration purposes only.
1. Drill a 5/16" hole through the roll-up conduit 1/2" from
the end.
Threaded Rod
Purlin
End
Rafter
Guide
Channel
Carriage
Bolt
Roll-up Side
Conduit
Frame shown
may differ from
actual frame.
2. Insert a tubing adapter into conduit and align holes of
adapter with drilled holes in conduit.
