GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
22
113836_37_38_39 Revision date: 06.06.18
END PANEL INSTALLATION (continued)
In photo below, top of panel is removed using a power
tool equipped with a round cutting bit. Use rafter as a
guide for best results.
NOTE:
Actual greenhouse frame may differ.
4. Continue installing panels and aluminum profile in the
locations shown on the end panel diagrams (Quick
Start section) for the front and back end walls.
ATTENTION:
The u-channel profile for the top edge of
all panels (dashed line below) is installed last and after
all profile is installed along edges and between each
panel as shown on the end panel diagrams.
Cut upper panel
to proper length.
Outside edges of panels are finished with aluminum
u-channel profile (104213). Consult diagrams for
details.
U-channel profile (104213) is also installed along panel
bottoms
above doors
to finish those edges.
5. After installing all panels, cut and attach profile to the
remaining upper edge of all polycarbonate panels.
NOTE:
For the curved panel edge, prepare u-channel
profile as shown below:
a. Cut angled notches from profile to allow bending.
The tighter the curve, the closer the notches.
b. Distance between notches is determined by the
degree of the bend needed to match the rafter.
c. Bend the u-channel profile at the notches before
installing it.
6. Repeat the procedure for the remaining end panels at
the other end wall.
7. Continue with the
Double Door Assembly
procedures.
Install profile here.
