12
12
115277
Revision date: 09.25.18
Diagram shows pvc tube with drilled drain holes and channels on
support tube. Channels are added in a later procedure.
4
ASSEMBLE AND ATTACH 2" PVC DRAIN MANIFOLD
Assemble and Attach 2" PVC Drain Manifold
ATTENTION:
During the assembly of the 2" drain
manifold, dry fit all pvc tubing and fittings
before
applying the pvc adhesive
.
Complete these steps:
1. Cut one piece of 2" pvc pipe to 53" and snap it into the hangers at one level of the frame.
ATTENTION:
Center the pvc pipe so 1" extends past the outer edge of the vertical frame tube at each end.
2. Rotate the pipe in the hangers so the printing on the pvc is centered on top. (Printing is used to maintain alignment when drilling holes.) Mark the inside
edge of each hanger on the pvc pipe as shown. Marks are used to realign pipe with the hangers after drilling.
3. At one end of the pipe, measure 6"
in from the hanger
and mark. This is the position of the first drain hole.
4. From the mark in Step 3, measure and mark the on-center locations for the drain elbows of all channels. See diagram for on-center dimension.
53"
6"
6"
12"
12"
12"
1"
Step 2:
Mark pvc.
Step 3: Mark pvc–
first hole location.
Step 2: Mark pvc.
ATTENTION:
Check hole positions
before
the next step! There should be four (4) hole positions marked on the tube when finished. Holes should be
evenly spaced and equal distance from each end of the pvc tube. Measure and remark if holes are not marked correctly.
