48
5.7.4. Tyres use & maintenance.
Ciśnienie w ogumieniu należy sprawdzać co 10 mtg lub w danym dniu przed rozpoczęciem pracy
Check tyre inflation pressure every 10 hours of operation or daily before starting work.
WARNING:
!
These rules, if followed carefully, will ensure maximum tyre life:
Apply recommended tyre pressures, check that the tyre pressures are correct for
the particular operation to be performed. In certain conditions the pressures may be
lowered, particularly where the loads are light or the soil is very humid, resulting in
the tyre tread failing to self clean. If the tyre pressures are reduced, have someone
observe the tractor. Do not exceed 20 km/h on the road, if the tyre pressures have
been lowered for ploughing.
Keep oil grease and strong alkaline or acid fertilizers away from the tyres to prevent
deterioration of the rubber.
re-vulcanized any small sidewall, or thread splits or cuts, as soon after they occur
as possible. This extends the life of the tyre.
Tyre inflation pressure at one axle wheels must be equal.
5.8. Clutch.
Every 50 hours of operation grease:
a) with grease,
-
clutch linkage pedal pivot (1-Fig. 5.8.1),
-
clutch pedal pivot
b) with grease-maintaining agent - clutch linkage attachment pivot in clutch pedal lever fork
Fig. 5.8.1. Free travel adjustment of transmission
clutch pedal. 1 – Clutch linkage pivot grease point.
2 – Lock nut.
Check and adjust, if necessary, the free travel of transmission clutch pedal every 50 hours of
operation.
To adjust (Fig. 5.8.1):
loosen the locknut 1 and remove the split pin and clevis pin,
turn the clevis to lengthen or shorten the operation rod, as required,
secure the clevis pin with a new split pin and tighten the locknut.
With correct lever setting, clutch pedal free travel is 32
38 mm.
