INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA /
Ο∆ΗΓΊΕΣ
ΑΣΦΑΛΕΊΑΣ
/
ИНСТРУКЦИИ
ПО
ТЕХНИКЕ
БЕЗОПАСНОСТИ
Lípari ref 33362
faro - 30
Note: do not blade or blade arm to prevent wobble
OPERATION
1.
Your fan can be operated from the remote control giving you the six speed choices.
2. do not connect the fan directly to power.
3. that fan is not suitable to work with a wall control. We are working to make a wall control for that fan.
The slide switch on the top of the fan housing controls forward or reverse rotation. Make sure switch is not stuck
between forward and reverse position.
IMPORTANT: to prevent damage for fan motor when changing direction of rotation, please be sure that fan is off and
blades have stopped moving completely before attempting to change direction.
CARE AND CLEANING
Periodic cleaning of your new ceiling fan is about the only maintenance that is needed. Only use a soft brush or lint free
cloth to avoid scratching the finish. NO NOT use water when cleaning your ceiling fan. It could damage the motor or the
wood blades, and/or create the possibility of electrical shock.
NOTE: periodically it may be necessary to re-tighten blade screws to prevent clicking or humming sound during
operation. This is especially true in climates with broad temperature and humidity ranges and the fans with painted or
high gloss blades. When dusting the blades, you must support the blade to prevent bending no pressure should be
applied to the blades.
If you experience any flaws in the operation of your fan, please check the following points:
TROUBLESHOOTING IN CASE OF DIFFICULTY
CAUTION: Switch off the power supply before carrying out any of these checks.
1.
If will not start: Check main and branch circuit breakers and/or fuses. Check line wire connections to fan. Make
sure forward/reverse switch is set to one or the other position, not stuck in between
2.
If the fan is noisy: Check and make sure that all screws in motor housing are snug (but not over tight). Check that
the screws securing blades to the motor are tight. Check all glassware is finger tight and that bulb are well held in the
sockets, if a light kit is used. Check that the canopy is firmly attached to hanging bracket and not vibrating against
ceiling.
3.
If fan wobbles: Check all blades are firmly screwed into motor. Check to make sure that light is firmly attached and
that all glassware and shades are fastened properly. Wobble can also result for even the smallest deviations in
distance for blade tip to blade tip, if measurements from blade tip to blade tip are not equal, loosen screws connecting
blade to motor one at a time and adjust blade so that distance are equal. Interchanging adjacent blades may
redistribute mass and result in smoother operation.
Summary of Contents for Lipari
Page 1: ......
