Mounting the Belt-Clip Plate and Belt-Clip
Figure 5-2 Attaching the Mounting Plate
Attach the included mounting plate using the screw as shown in the picture above onto the Mobile PC.
Use an SW4 torque wrench to tighten the screw to between 0.5 Nm and 1.5 Nm. Too much torque can
damage the housing, while too little may not firmly attach the mounting plate.
NOTE:
If you don’t have a torque wrench, tighten the screw until you cannot turn the mounting plate
with your fingers easily. This is probably close to the required torque.
Mounting the Belt Clip
FARO Freestyle 2 User Manual
Chapter 5: Prepare to Scan
FARO Freestyle 2 (August 2020)
Page 22 of 58
