En
FARO Photon Laser Scanner – User’s Manual
25/68
Revised: April 10, 2008
© 2008 FARO Scanner Production GmbH
File Basename
- The scan will be saved with a file name consisting of this base name
followed by the current scan number, e.g. Scan000.
Scan Number
- Automatically increments with each successive scan. Can be reset and
may be used to indicate the number of scans per scan session.
Path on Scanner
- This is the file path to store the scans directly on the scanner.
Path on Operating PC
- The file path to store scans on the Operating PC.
Free Space on Operating PC
- the free disk space on the Operating PC.
File Info
- Additional file info.
Storage Mode
- There are three storage modes:
•
Automatic
- The scan is saved to the device where the scan was started.
•
Scanner
- The scan is saved to “Path On Scanner”.
•
Remote
- The scan is saved to “Path On Operating PC”.
File Split After
: Split the scan files after a certain amount of columns.
6.3.1.4 Operation and Operator
In order to organize your scans, you can supply further details about the scans. The
information will be saved together with the scans.
Fig.29
Operation and Operator
Operation
Name
- Provides information about the project name.
Company
- Project company’s name.
Division/Subdivision
- The division/subdivision of the project company requiring
scanning services.
Area
- The area within the factory/project to be scanned.
Info
- Any additional information required for the project, e.g. contact person or areas of
focus in the project.
Min. Reflection
- The minimum reflection value. Only brighter scan points are recorded.
