Faroudja DVP 1080, Installation And Operation Manual

(DVI output - Continued)

NOTE #2:

 With HDCP encrypted sources, it can take

up to 30 seconds for the HDCP authorization between

source and display to be acquired. The display device

must be HDCP compatible to get an image.

NOTE #3: 

Higher resolution displays require higher

quality DVI cables. Using cables not rated for the

resolution being used will result in images with

colored sparkles and lines. Always verify maximum

resolution rating of the cable with cable supplier.

For 1080p, fiber optic cables must be used for

lengths over 15’ (cables rated for 1600x1200 resolu-

tion).

NOTE #4:

 The SETUP menu offers selections for

setting the output type. See Page 10 for details.

10. DB9F RS232 CONNECTOR:

 Use for control

system interface.

NOTE#1:

 The SETUP menu offers selections for

RS232 operation.  See Page 11 for details.

11. RGBHV/YPrPb ANALOG OUTPUTS:

 For use

with high scan rate analog displays.

NOTE #1: 

If a HDCP encrypted DVI source is

selected, the analog outputs are deactivated by law.

In this case, the  front panel LCD will display:

ENCRYPTED SOURCE

ANALOG OUT DISABLED

NOTE #2:

 RGBHV (5-wire) is highly recommended

to use over YPrPb (3-wire).

NOTE #3:

 The SETUP menu offers selections for

output type. See Page 10 for details.

NOTE #4:

  RGBHV must use 5-wires. Be careful not

to swap the H&V cables

.

 Only use high quality 75ohm

cables.

12. AC POWER CONNECTOR

Connect to a stable 120-220volt power line.

NOTE #1: 

To avoid ground loops, a power

conditioner for the equipment rack is recommended.

NOTE #2:

 Static electricity can cause equipment

problems. Be sure installer is grounded to chassis or

equipment rack before connecting sources.

10

Notes