Faroudja DVP 1080, Installation And Operation Manual

SET:DVI INPUT

16-235 / 

0-255

Sets the correct input signal level to match the DVI

input source.

NOTE #1:

 0-255 is typical for digital display devices

inputs (the processor output is 0-255), 16-235 is

typical for video sources. However, not all sources

follow the rules. If the processor DVI input level is

set to 0-255 but the source is 16-235, the image will

lack dynamic range.

Note #2:

 To test what the output is from the

source, put up a 10 step gray scale pattern from a

test pattern DVD. Toggle between 16-235 and 0-255.

The correct setting is when all 10 bars are visible and

evenly lit. An incorrect setting will produce an image

that either looks dull or the brightest and darkest

bars are missing (clipping).

0-225 16-235 Setting = Image too bright

16-235 0-255 Setting = Dull Image

SET:OUTPUT FORMAT

RGB

 / YPrPb

Sets the analog output format when the processor

OUTPUT TYPE is set to ANALOG in the SETUP menu.

NOTE #1:

 If DIGITALI&ANALOG is selected as the

output type, RGBHV is the only analog output format

allowed.  YPrPb is deactivated.

NOTE #2:

 If a HDCP encrypted DVI source is

selected, the analog outputs are deactivated by law.

The front panel LCD will display:

ENCRYPTED SOURCE

ANALOG OUT DISABLED

RGB means RGBHV (5-wire), YPrPb means 3-

wire. RGBHV will provide the best results. Many

display devices have only limited compatibility with

YPrPb signals.

SET: COMP SYNC ON H

ON / 

OFF

Sets H&V sync as composite sync on the H connector

when using analog RGB output (4-wire connection).

Note #1:

This option defaults to AUTO and is locked

when YPrPb output is selected.

RGBHV is recommended for best results.

INPUT ENABLE / DISABLE

Each input can be enabled or disabled depending on

the installation.  Deactivating unused inputs helps to

streamline operation. Each input is listed in the

SETUP menu for control: VIDEO-S/VIDEO-RGB-

YCrCb-DVI-PASSTHRU

NOTE#1:

 The VIDEO input cannot be disable to

prevent having all inputs disabled making the unit

non-functioning.

SET:RGB INPUT SYNC

SYNC-ON-GREEN / 

COMPOSITE SYNC

Sets the sync type for the RGB input.

NOTE #1:

 Composite sync option should be selected

when using PAL RGB.

SET:DVI INPUT H SYNC

NORMAL

 / WIDE

Sets the DVI sync position. With some nonstandard

DVI sources, selecting WIDE will correct improper

sync timing (seen as a horizontal image shift).

SET:OSD

ON

 / OFF

Sets if the On-Screen-Display is visible.

SET: OSD TIMER

0-255 

(30 DEFAULT)

Sets how long the OSD will be visible

SET: LCD TIMER

0-255 

(30 DEFAULT)

Sets how long the front panel LCD backlight stays on.

0=OFF, 255=ALWAYS ON

SET: RS232 ECHO

ON

 / OFF

Sets if command echos are sent back to the RS232

control device. See page ## for RS232 codes.

SET: BAUD RATE

9600/ 

19200

 / 57600

Sets the RS232 communication baud rate.

SET: SCREEN TRIGGER

OFF / 

ON

Allows programming of 12volt external trigger to

control accessories such as screens and motorized

lenses. OFF sets the 12v to NOT turn on when the

unit is powered up.  ON sets the 12v to turn ON.

Store each command as a profile to select using the

remote or use RS232 commands.

12