III. ENGINE REPAIR
48
Slide the eccentric shaft through the
bearing bush in the housing and into the
control lever. Turn the acceleration lever
downwards („stop“-position) until spring leg
of the return spring can be managed to get
into the notch of the eccentric shaft.
(Figure 16c)
Use a wire loop to move and hook torsion
spring leg to the boss of the gear housing.
(Figure 16d)
Push eccentric shaft further in and push
ring spring into the notch of the eccentric
shaft.
(Figure 16e)
Attention:Initiate performance test.
The tension of the return spring must be
acting against the pressure onto the binding
screw.
(Figure 16f)
Regulation - Stationary
The outer torsion spring pulls the
acceleration lever from the stop - position
back into the idle position.
Regulation -
Vehicle/Bowden Cable
The outer torsion spring pulls the
acceleration lever in the stop - position.
Attention:The spring tension may be
altered by hooking the spring leg into
one of the neighboured notches.
(Figure 17)
10. Piston
Install the piston rings using a ring
expander so that the imprinted „R“ is on
top.
(Figure 18)
Summary of Contents for 15D Series
