480 Budget - Issue 00
11
6.4 INSTALLATION
Once the vending machine has been unpacked, it can be set at work following the instructions below:
The machine must not be exposed to direct sunlight or inclement weather. The machine
must not be installed in areas where jets of water may be used. The machine can be
installed in places with ambient temperature ranging from 3°C to 32°C.
1)
Ensure that the main switch is in the "OFF” (O) position and that the fuses are securely in place.
2)
The equipment must be supplied with single-phase voltage 230V 50Hz with the general switch off.
IT IS ESSENTIAL THAT THE EQUIPMENT BE CONNECTED TO A POWER SUPPLY
MAINS EQUIPPED WITH EARTHING IN ACCORDANCE WITH THE LAWS IN
FORCE. THE VENDING MACHINE MAINS MUST BE PROVIDED WITH A
DISCONNECTING DEVICE WITH MIN. 3 mm CONTACT OPENING. ENSURE THAT
THE PLUG IS ACCESSIBLE ONCE INSTALLATION IS COMPLETE.
E
N
G
L
I
S
H
WARNING
The following instructions are relative to point 2 and only apply to
the United Kingdom
The wires in the cable are coloured coded as follows:
GREEN AND YELLOW - EARTH ---- BLUE - NEUTRAL ---- BROWN - LIVE
As the colour of the wires in the cable of this equipment may not correspond to the
colour marking in the terminals of your socket, proceed as follows:-
The GREEN and YELLOW wire must be connected to the socket terminal marked
with the letter E or with the GREEN or GREEN and YELLOW earth symbol.
The BLUE wire must be connected to the socket terminal market with the letter N or
coloured BLACK or BLUE.
The BROWN wire must be connected to the socket terminal marked with the letter L
or coloured RED or BROWN.
The manufacturer cannot be held responsible for damages caused by the failure
to observe the precautions given above.
3)
After having positioned the machine, adjust the four adjustable feet so that the machine is perfectly
horizontal; all the feet must be in contact with the floor.
4)
To ensure adequate air circulation of the refrigeration unit, install the conveyor supplied with the machine
following the instructions given on the conveyor itself.
Check that the grids behind and under the refrigeration unit are kept clean and unobstructed.
It is not recommended to install the covers of the front legs in environments where the ambient
temperature exceeds 30°C.
Failure to install or incorrect installation of the rear conveyor annuls the guarantee.
If the machine is to be fitted into a wooden cabinet or similar housing, ensure that the grills and the lower
sides of the machine are kept clear for ensuring adequate air circulation.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
Summary of Contents for 480 BUDGET
Page 1: ...480 BUDGET Issue 00 03 2004 Cod 22056301...
Page 2: ......
