........................................................................ 9
...................................................................... 9
................................................................... 9
....................................................................... 10
Please make sure to read this manual carefully before start up this
versatile electronic equipment.
【
Note
】
1.
T
he walk-through metal detector (WTMD) can not be operated outside without
weather shed.
2.
Probe can not be fixed in hot/ humid environment.
3.
Assemble your equipment on a horizontal and flat floor to avoid emitting false
signal caused by rocked gate.
4.
Distinguish the right side and left side panels, and confirm the plug of sensor
will be plugged in the relevant marked place.
5.
Finishing 1 minute of self-checking after starting up, the equipment achieves
optimum efficiency.
6.
Persons who walk through the machine should obey: internal time is above 1
second.
7.
Do not knock the machine when operating, for avoid emitting false signal,
even damage.
8.
Use soft, damp clothing or dipped alcohol clothing to clean your equipment.
Always unplug your equipment during cleaning.
9.
Inner has high-tension, unprofessional don’t open it, avoid backfiring.
10.
With Warranty Card, every machine will be free of maintenance under
warranty.
【
Introduction
】
Stabilizer Base
Power Cord Outlets
1.
Main Control 2.Top Cover 3.AL Strip 4.Panels 5. Metal IR Probe
6.
Stabilizer Base
7.Outlets 8.
LED Zone Lights
9. Temperature IR Probe
Walk Through Metal Detector (WTMD) is a kind of fixed appliance, used
especially for finding the person who carries hidden metal objects. When a person
walk through the WTMD, if the metal objects he carried are more than the setting
level, the WTMD will alarm and show the alarm zone instantly.