Before each use:
ATTENTION
Before proceeding with the operation of lubrication, detachment / attachment, adjustment or
installation of accessories, disconnect the air supply hose from the tool, having first taken care
to close the tap of compressed air supply
1)
Drain water from air compressor tank and condensation
ATTENTION
Always use clean, dry air at 90 PSI (6.2 bars) maximum air pressure. Dust, corrosive fumes
and/or excessive moisture can ruin the internal components of a pneumatic tool.
2)
Lubricate the
3)
Install the accessories (sockets, extension bars, etc...) verifying its integrity and that they are securely housed.
USE:
1.
Turn air compressor on and allow air tank to fill.
2.
3.
Connect tool to air hose of recommended size (see the Technical specifications paragraph of this user manual)
WARNINGS
-
raccomanded from
the producer with this tool.
-
Do not use hand sockets and accessories because they are not endowed of appropriate
locking systems.
-
Use inpact wrench extension anvil only when needd.
-
Before assembly the accessories (sockets, extension bars,...) on the tool, always check the
integrity of their locking systems.
ATTENTION
-
Before to use the tool, always check the integrity of the tool and of its accessories.
-
Before to start the tool, always check to have correctely set the accessory.
ATTENTION
Do not use damaged, frayed or deteriorated air hoses and fitting
4. INSTRUCTIONS FOR USE OF THE TOOL
F
G
A
3
09
A
IR
I
M
P
A
C
T
W
R
E
N
C
H
1.
TRIGGER
2.
SWITCH ROTATION
3.
POWER SWITCH
1
2
3
