Fasep 2000 srl
Rev. 1.1
Balatron B350.G3
10 September 2012
2-2
1.2
Lifter - Intended Use
The lifter of this wheel balancer is designed to move wheel of vehicles complete with tire, with size and weight within the work range
specified (see Appendix 'Technical Data').
This unit is meant for a professional use. Operator shall be properly trained before use, and in any case must carefully read the
“User’s manual”. This unit is designed for indoors use.
- It is expressly forbidden to use the lift to move, raise and lower anything other than a wheel for vehicles.
- After positioning the wheel on the sliding wheel support of the lift, the wheel must be anchored with safety
chain before performing any handling
- Any other use than those specified shall be deemed prohibited, not provided by the manufacturer and therefore
potentially dangerous.
2
INSTALLATION
2.1
Moving the unit
WARNING
When the unit has to be moved: never lift
balancer by motor shaft or by neighborhood of it.
2.2
Assembling the unit
For ease of transportation, the wheel balancer might be disassembled
into units. If necessary, assembling instruction are provided within
each package.
2.3
Installation
The wheel balancer must be installed on a firm and level ground.
NOTE
:
the machine must be secured to the floor. Using four holes
in the base and anchor bolts provided.
2.4
Electrical Hookup
!
CAUTION:
Failure to follow these instructions can results in
damage to unit or create an electrical hazard and
will void warranty.
2.4.1
Electrical hookup is to be provided by a qualified electrician.
2.4.2
A fusible wall-mounted switchbox is required at the installation site.
This switch should provide on-off control and overload protection for your wheel balancer only. The switchbox should be
fused with time-delay fuse(s) in accordance with the power rating specified on your wheel balancer.
2.4.3
Electrical connection of the machine should be by plug connectors.
2.4.4
The balancer must be effectively connected to ground. The electric cord is regularly provided with a ground terminal.
2.4.5
Make sure that Power Rate Specifications for your wheel balancer (refer to nameplate on the wheel balancer) comply
with those provided by the external power source.
!
CAUTION
After electrical hookup has been performed unit is ready to operate. Always observe pertinent safety
precautions when operating the unit (see Appendix tables for an overview of relevant Safety
requirement).
