Fasep 2000 srl
Rev. 1.0
Balatron B150: User’s Manual
07 June 2016
5-1
5
MEASUREMENT AND CORRECTION OF UMBALANCE
5.1
Placing the wheel on the wheel balancer
5.1.1
Select the cone or flange suitable for the wheel to be balanced.
NOTE
:
the operation of centering and tightening of the wheel on the flanges is of basic importance for correct
balancing. Good results depend on proper performance of these procedures.
Clean accurately all cones, shaft and adappter surface before placing the wheel on the wheel balancer.
!
CAUTION:
Always make sure flanges are correctly locked on the motor shaft and wheel is correctly locked
on the flange being used.
5.1.2
Lower the balancer through lift handle
5.1.3
Mount the flange
5.1.4
Near the wheel balancer to the wheel
5.1.5
Mount the wheel and the mating flange on the shaft
5.1.6
Lock the wheel on the shaft through locking handle
5.1.7
Lift the balancer through lift handle
NOTE
:
First of to proceed at the measure of the umbalance report the unit in position completely higher.
Summary of Contents for BALATRON B150
Page 39: ......
