20
User’s manual
• Tool positioning (fig.14 - 15)
- Tilt the tower forward by pressing the tower tilt
pedal
- Set the mounting bar in its working position
and let the mounting head touch the edge of the
rim.
- Press the yellow button from the outside of
the handle to lock both the mounting bar and
the horizontal arm. The mounting head will
automatically move 2/3 mm. away from the edge
of the rim, thus protecting it from damage.
DEMOUNTING
- Position the tyre lever between the mounting head and the tyre bead and lift the bead above the
forward portion of the mounting head itself.
- Make the turntable rotate clockwise by pressing the relevant pedal lightly and repeatedly, then
keep the pedal continuously pressed.
- Rotate the wheel through one turn and at the same time press down with a hand on the side of
the tyre opposite to the mounting head, in order to position the bead in the central groove of the
rim.
-
If the wheel has an inner tube
, remove it after swinging the horizontal arm + mounting bar in
non-work position.
- Repeat the above described procedures to take out the second bead. Then move the horizontal
arm + mounting bar in non-work position and take the tyre off the rim.
15
13
14
