8
User’s manual
UNPACKING/ASSEMBLY
WARNING
Take utmost care when unpacking, assembling, hoisting and installing the machine as described
in this heading.
Keep the original packing in good conditions to be used if the equipment has to be shipped in the
future and make sure that the machine has not suffered damage in transit.
Failure to comply with these instruction may damage the machine and risk the operator’s safety.
Remove the upper part of the packing.
Proceed with the following operations:
- Remove the tower (hori vertical arms) from its position on the pallet.
- Free the mounting bar from the wooden lath that is keeping it locked. During this operation it is
advisable to keep the mounting bar in lowered position with a hand.
- Remove side cover.
- Fit the tower and in the meantime insert pneumatic hose A into its proper hole on the machine’s body.
- Check that rod P of the tower tilt cylinder is inserted in the U-bolt Q. Insert pin R and fasten it with
self-locking nut S without tightening it to the bottom.
- Fasten the tower on the machine’s body with the T.C.E.I. screw; do not forget to interpose the
notched washers which allow the electric continuity of the machine.
- Connect hose A to the valve placed on the pedal unit base inside the machine’s body and controlled
by the horizontal arm swing pedal.
- Press protection N in its original seat.
- Fit the side cover.
- Assemble the bead breaker with the proper pin and fasten it with the locknut until there is a slight
resistance in the rotation of the bead breaker.
HOISTING/HANDLING
To remove the machine from the pallet :
Lift the machine sideways enough to insert the forks of the fork-lift truck between the machine and
the pallet as showed in fig.2.
At this point is possible to release the working arm removing the cord which binds the arm to the
turntable.This hoisting point must be used whenever you need to change the installation position of
3
800
800
700
®
2
