18
Tire preparation fig.22 :
Grease both the tire beads (inside and outside).
Place the tire on the rim.
MONTAGE
CAUTION :
Always check that the tire/rim combination is correct in terms of compatibility
(tubeless tire on tubeless rim; tube type tire on tube type rim) and geometrical size
(keying diameter, cross-section width, Off-set and shoulder profile) before mounting.
Also check that rims are not deformed, that their fixing holes have not become oval,
that they are not scaled or rusty and that they do not have sharp burrs on the valve
holes.
Be sure that the tire is in good condition with no signs of damage.
22
Head positioning :
- set the mounting bar in work position.
The tool is already in the correct position for mounting the tire.
Lower bead mounting :
Place the bottom bead of the tire underneath the tool fig. 23 - 24 and at the same time apply a little
pressure to the tire by hand while starting to rotate the wheel (pedal 1 ) for easier bead insertion.
Rotate until tire mounting is complete.
23
24
Summary of Contents for RASE.TOP.2248
