Original notice – User’s manual
22
8.
OPERATING CONTROL
WARNING
Before use, check all levels, correct tightening, correct tension, correct
fastening, correct connection of all parts of the device. Also check the
operation of the emergency stop button.
1. Start the device by following steps 1 to 8 of "9.1. Starting and unfolding" (page
23).
2. Move the manipulator C downwards and pull out the device until the mandrel
holder is parallel to the ground.
3. Loosen the handle of the stand and pull out the stand approximately 20 cm,
then tighten the handle.
4. Actuate the manipulator C downwards until the device is fully lowered. Make
sure that the stand touches the floor and that the other parts do not touch the
floor (minimum space of 4 cm between the floor and the mandrel holder). The
stand must be slightly supported (the van must not be lifted). If this is not the
case, repeat step 3 of this procedure by increasing the output of the stand.
5. Press the manipulator A downwards to lower the mandrel holder and
upwards to raise it.
6. Move manipulator A to the left to move the mandrel holder to the left and
right to move it to the right.
7. Press the manipulator C to the left to open the mandrel and to the right to
close it.
8. Press the left pedal and the right to check the correct rotation of the mandrel.
9. Press the manipulator A downwards to fully open the mandrel holder.
Continue to operate the manipulator A downwards and check that the
pressure of the manometer is between 130 and 180 BAR plus or minus 5%.
WARNING
If the value is not the one indicated, do not use the appliance and call us.
