Original notice – User’s manual
23
9.
USE
WARNING
Before use, check all levels, correct tightening, correct tension, correct
fastening, correct connection of all parts of the device. Also check the
operation of the emergency stop button.
Starting and unfolding
1. Determine the operational area.
2. Unhook the control console attached to the mandrel holder.
3. Open the air purge valve
A
.
4. Switch the pneumatic tire contactor
B
to "0".
5. Turn the ignition key
C
one step to the right.
6. Observe the preheating (orange light). While holding the green button
D
on
the tire machine, turn the ignition key until the engine starts (green light).
7. Close the air purge valve.
8. Turn the pneumatic tire contactor to "1".
9. Pull out the device until the mandrel holder is parallel to the ground.
10.
Loosen the handle of the stand and pull out the stand approximately 20 cm,
then tighten the handle.
11.
Pull out the device completely. Make sure that the stand touches the floor and
that the other parts do not touch the floor (minimum space of 4 cm between
the floor and the mandrel holder). The stand must be slightly supported (the
van must not be lifted). If this is not the case, repeat step 10 of this procedure
by increasing the output of the stand.
B
A
N
D
C
N
